How to Set a Wrought Iron Fence?
Wrought iron fences can help you make a statement and add to the curb appeal of your home. They are also a great addition to your yard because they can be customized with finials, scrollwork, and other decorative details. They are a popular choice for both homeowners and businesses as they can be made to match any style.
(Looking for a “Professional Fence Company“? Contact us today!)
The first step in setting a wrought iron fence is to determine the desired design and where the posts should be installed. You can use chalk dust to mark the spots where you plan to place each post, and then dig out the holes in the ground for them. It is recommended that you put each post approximately 6 to 8 inches apart.
Once the posts are in the correct position, it is time to install the panels and gates that go with them. You will need a few different tools to complete this job. These include a post-hole digger, shovels, a level, a tape measure, screwdrivers, and a wheelbarrow. Fasteners, post-hole plugs, and gravel are also needed for this project.
You will also need a bucket of water and a spray nozzle for this task. This will allow you to clean the fence and get rid of any accumulated dirt or grime. You can also wash the fence with a brush if necessary but avoid using an abrasive cleanser as this can scratch the surface of the wrought iron.
If you notice a problem with your wrought iron fence, it is important to repair it. This will prevent it from becoming damaged and help to keep it looking nice.
Fixing Bent Pickets If one of your wrought iron fence pickets is bent, it is probably time for some repair work. This may require the help of a professional welder, but you can try to fix the issue on your own with some ratcheting straps.
Begin with the bottom of the bend, and then work your way up to the top. This should take a little practice, but you should be able to make it. If you have difficulty, use a small hammer to apply pressure to the bent picket, and make sure that the bar on the other side of the bend is still straight before continuing.
Repeat this process for all of the other fence pickets, and then move on to the panel brackets. This will help to ensure that all of the pieces of the fence are in place and secured correctly.
When you are finished installing the panels, it is time to start attaching the top and bottom panels together. This will take some time to complete, as you need to line up the top and bottom brackets with each other. If there are any snags or gaps, it is possible to sand them down and fill them in with epoxy putty. Once this has cured, sand down the area again and then re-paint it with rust-resistant paint.
