How to Build a Wire Fence With Wood Posts?
Building a wire fence is not that difficult as long as you understand the process. The most important thing to do is to plan your installation so that you have a sturdy and well-secured fence. For this, you will need to follow some basic steps and use high quality fasteners.
(Searching in Google “fencing professional montana“? Contact us today!)
First, you will need to dig a hole for the fence posts. This should be at least 2 feet deep. It’s a good idea to put some gravel around the post to prevent water from entering the wood. You can use a post hole digger or a spade for this.
When you have your post in place, you will need to lay down a line of welded wire. Make sure that it is completely level. If it isn’t, you can use a level to help you make it level. Once you’ve done this, it’s time to attach the mesh. Follow the instructions on the package.
To start, it’s recommended to start at the corner of the fence. This will allow you to attach the brace post to the corner post. This will keep the two posts in place. Before you do this, you will need to measure the space between the posts. There is usually about seven to eight feet between the posts. However, it’s a good idea to consult with your local fence supplier for more precise measurements.
Next, you’ll need to attach the top and bottom rails of the fence. To do this, you’ll need to cut the wire mesh infill to fit between the posts. Generally, you’ll need to cut the infill to a size that is just a few inches larger than the rails. In addition, you should also staple the mesh to the top and bottom rails. As you staple, you should pull the mesh taut to secure it to the post.
After the first few sections of fence are done, you can continue with the rest of the fence. You can cut the wire infill to a size that fits between each post, but you can also roll out the fencing to cover the entire post. This makes the installation process much easier.
When you have finished the fence, you can now attach the top and bottom rails to the posts. These rails should be secured with 3-inch deck screws. Alternatively, you can use a Kreg jig to drill recessed screws into the rails. A Kreg jig is available online.
Finally, you’ll need to bury the bottom 2 x 4 support into the ground. Be sure to place it off-ground, however, so that water won’t build up on the wood. Also, ensure that the top 2 x 4 is at least six to ten inches up from the ground. That way, you can be sure that the fence is completely level.
Depending on your climate, you may need to adjust the length of the posts. This is especially true if you are digging them in the colder months.
