How to Remove Wrought Iron Fences?
If your wrought iron fence is starting to look a little dull, it might be time to clean it up. You might have to cut out portions of the fence to get to the rust. A simple cleaning can make a big difference in its appearance. However, if you are unsure of how to clean a wrought iron fence, you can always hire a professional to do the work for you.
(Searching in Google “Missoula Fence Contractor“? Contact us today!)
Before you begin, you will need to identify the bare metal areas on the fence. These can be wiped with a cloth or wire brush. The surface of the wrought iron should be sanded with 120-160 grit sandpaper. This will remove the rust and prepare the surface for an even coat of paint.
Once you have sanded the fence, you should rinse it thoroughly. Rust can be a hazard if it gets into the paint. Therefore, you should use a commercial rust cleaner. It should be applied to the fence in circular motions. To prevent rust, you can also mix lemon juice and vinegar together to create a rustproof metal. When the rust is removed, you can apply a protective spray.
Depending on the type of wrought iron fence you have, you may need to remove it altogether. Typically, a wrought iron fence is divided into sections that are attached to support posts. The support posts may be set in concrete or stone. They should not be forced out of the ground, as they could cause further damage to the fence.
Depending on the severity of the rust, you may need to sand down the entire fence. However, if it is only a few spots that need removing, scrubbing them out with a rust cleaner is usually enough. As long as you wear eye protection, you should be able to do this task.
If your wrought iron fence needs more attention than scrubbing, you can use a pressure washer to clean it. You will need to rinse off any excess water with a hose. While you are at it, you might want to remove any mildew. Using bleach diluted with water will help kill it.
Alternatively, you can try sanding the rust off with a flap wheel connected to an electric drill. This will help you remove any paint chips that may be left behind. Afterwards, you can buff the fence with a fine steel wool pad to restore the natural color and finish of the iron.
Another solution to prevent rust is to apply a rust-inhibiting primer to the bare metal surfaces. This will seal the metal from moisture and help it to resist corrosion. After the primer is applied, you can apply a rust-resistant paint.
Getting your wrought iron fence cleaned up will help to keep it looking great for years to come. It is best to keep it free from damage by grass and plants. Also, don’t forget to document its condition. Take pictures of it before and after.
